Setting Up Key Chain Remote And Panic Buttons - X10 Orca2000 Owner's Manual

SETTING UP KEYCHAIN REMOTE & PANIC BUTTON
The Keychain Remote and Panic Buttons are shipped with the batteries fitted and
the units pre-installed into the Console, so everything should work straight out of the
box. If you need to re-install anything (after changing batteries for example) follow
the steps below.
Key Chain Remote
1. Install 2 AAA alkaline batteries in the
KR16A Keychain Remote's battery
compartment.
2. Set the INSTALL/RUN switch on the
Console to INSTALL (located under
the flip up door).
3. Press and hold PANIC on the
Keychain Remote for about 4
seconds. The Console chimes.
4. Set the Console's slide switch back
to RUN1 or RUN2.
5. To set up additional key chain
remote controls* repeat above
steps.
Panic Button
1. Install 2 AAA alkaline batteries in the
KR15A Panic Button's battery
compartment.
2. Set the INSTALL/RUN switch on the
Console to INSTALL (located under
the flip up door).
3. Press and hold the red Panic Button
on the KR15A for about 4 seconds.
The Console chimes.
4. Set the Console's slide switch back
to RUN1 or RUN2.
5. To set up additional Panic Buttons *
repeat above steps.
One of the 6 included Panic Buttons is
black in color. This one can be placed in
a special compartment on the dorsal fin
of a 26" long Lucky ORCA Whale.
* You can install a combination of 16
Panic Buttons and/or Keychain
Remotes.
7