Setting Up For The Monitoring Station - X10 Orca2000 Owner's Manual

SETTING UP FOR MONITORING BY ORCA
Introduction to digital
monitoring
The ORCA Panic System incorporates
the same digital communicator
technology found in expensive high-end
security systems. Features supported
include remote configuration and alarm
type confirmation.
When the Console is tripped, a loud
piercing siren sounds and lights
connected to Lamp Modules flash on and
off. It then calls ORCA Monitoring
Services and sends a digitally coded
message allowing the station operator to
identify your address, telephone number
and even the type of alarm which
occurred (in this case Panic).
Registering with ORCA
Monitoring Services.
Once you have installed the system you
are ready to set up for monitoring. To
do this, all you need to do is:
• Fill out the enclosed monitoring
agreement and mail or fax it to ORCA
Monitoring Ser vices.
• Call ORCA Monitoring Services at
1-800 FOR ORCA (1-800-367-6722)
and follow the instructions to have
your system initialized.
Note: Although you can register your
system as soon as it has been installed,
the ORCA Monitoring Services will not
respond to alarm calls until the signed
monitoring agreement has been received
and you have been allocated your security
code which will be notified to you by
return.
Calling Customer Service
After you have registered your system
you can easily call the customer service
center if you need help, or to change
any of the default options as follows:
• Set the Console slide switch to RUN1
or RUN2.
• Press the MONITOR button. The
Console automatically dials the
customer service number.
• Pick up the handset of a phone
connected to the same line as the
Console.
Alternatively, you can dial the telephone
number in the usual way with any
telephone connected to the same line
as the Console - just pick up the
telephone and dial 1-800-FOR ORCA
(1-800-367-6722).
9