Table of Contents
Advertisement
SETTING UP REMOTE CONTROLS
Security/Home Automation
Remote Control
PANIC
PANIC
ARM
DIS-
HOME
ARM
ARM
DIS-
AWAY
ARM
SECURITY
LIGHT
ON
OFF
A
BRIGHT
DIM
O
C
M
E
ENTRY
K
G
DELAY
INSTANT
I
1. Install four AAA alkaline batteries in
the battery compartment (batteries
sold separately).
2. Set the INSTALL/RUN switch on the
console to INSTALL (located under
the flip up door).
3. Press ARM HOME or ARM AWAY
on the security/home automation
remote control. The Console emits
a tone.
4. Set the consoles slide switch back
to RUN1 or RUN2.
Note: If you do not hear a tone, press
the CODE button (located on the front
under the label) with a pencil, then
reinstall the remote as described above.
8
All manuals and user guides at all-guides.com
Key Chain Remote Control
1. Install two AAA alkaline batteries in
the battery compartment (batteries
sold separately).
2. Set the INSTALL/RUN switch on the
console to INSTALL (located under
the flip up door).
3. Press ARM on the key chain. The
Console emits a tone.
BATTERY
ARM
PANIC
DISARM
LIGHTS
ON
LIGHTS
OFF
4. Set the console's slide switch back
to RUN1 or RUN2.
5. To set up additional key chain
remote controls (up to eight), repeat
steps 1 and 2.
Note: If you do not hear a tone, remove
the batteries and then hold down the
ARM button for 3 seconds. Refit the
batteries and press ARM again. The
LED indicator will flash twice. You can
now install the key chain remote as
described above.
You can install any combination of
Remote Control types for a total of up
to sixteen Remote Controls. For
example, you can install eight key chain
remote controls and eight security/home
automation remote controls or any other
combination for a total of sixteen.
SETTING UP DOOR/WINDOW SENSORS
Installing Door/Window
Sensors
We recommend that you purchase
enough sensors to protect the front and
back door and any windows that are
obscured from view or easily accessible
(including basement windows).
DELAY
MAX
MIN
TEST
1. Mount the Door/Window Sensor and
the magnetic switch in the intended
location using the supplied screws
or double sided tape.
2. Install the magnet using the supplied
screws or double sided tape. The
arrows on the Door/Window Sensor
magnet and switch should be
aligned carefully so that they face
each other.
Note: The sensor and magnetic switch
supplied are already connected
together. If the wire is too long, you can
shorten it by cutting it to the length
required, stripping the ends and
reconnecting to the magnetic switch.
Initializing Door/Window
Sensors
This Procedure initializes the Door/
Window Sensors so that the Console
recognizes signals from the sensor.
1. Install two AA alkaline batteries in
the battery compartment (batteries
sold separately).
2. Set the INSTALL/RUN switch on the
console to INSTALL (located under
the flip up door).
3. Press TEST on the Door/Window
Sensor and hold for about a second.
Release the TEST button and the
LED blinks twice to confirm it has
been initialized.
+
–
DELAY
MAX
MIN
–
+
TEST
9
Advertisement
Table of Contents
