Wyse V90L Quick Start Manual page 8

Wyse Customer Support
TFTPD (Figure 7)
i. Setup TFTPD. From "Start", go to run and browse
C:\inetpub\ftproot\rapport\tools\sa\util and run the file TFTPD32.exe.
ii. Enter the following information in the TFTPD32 settings screen (Figure 7)
• Security = None
• Server Configuration
o Timeout = 3
o MAX Retransmit = 40000
o TFTP Port = 69
• Base Directory
o C:\InetPub\FTProot\Rapport\Tools\sa
• Advanced TFTP Options
o Option Negotiation = Enabled
o Show Progress bar = Enabled
o Activate Tftpd32 on this interface = Enable
iii. Click "OK" and close the window.
Figure 7 - TFTDP Settings
DHCP Turbo (Figure 8)
DHCP Scope need not be set, but here are the recommended parameters:
QSG - WSI 1.3.6 v3.doc
Scope Information:
Start Address: 10.1.1.13
End Address: 10.1.1.20
Mask: 255.255.255.0
Lease: 6 Hours or less
Figure 8 - DHCP Turbo settings
Pager 8 of 15