Wyse Customer Support
10.
The TFTP application will automatically launch. Note: this application window
should not be closed until the client is successfully imaged with the new
firmware.
11.
Wait for the message 'Please start/restart the client to start imaging'.
12.
Click "Ok" and the "Log message" screen will appear.
Start/Reboot the client. When client finishes the imaging process, the Log screen will
display the log messages and the final status. If the imaging was successful, 'Success'
will be displayed. If it failed, it will display an error message.
QSG - WSI 1.3.6 v3.doc
Figure 13 - TFTPD Application window
Figure 14 - Restart Client Message window.
Pager 12 of 15