Wyse Simple Imager Usage - Wyse V90L Quick Start Manual

Wyse Customer Support
W S I
YSE IMPLE MAGER
1. Connect the client (to be imaged) to the Wyse Simple Imager machine, through a
hub, unmanaged switch or cross-over cable.
2. Launch Wyse Simple Imager
3. Select the appropriate Product you wish to image from the Product list.
4. Click on the "Add" button Figure 5
Figure 10 - Select Product and Firmware
Note: A recent change in manufacturing to make our devices ROHS compliant, required us to
use different hardware components and make changes to the software to accommodate and
recognize these components. To address this issue and to prevent any damage to the hardware
with Wyse Simple Imager, new "Product Numbers" where added.
To avoid an "Incompatible Firmware" message or an "Imaging and re-booting" loop,
check the part number of your thin client, and use the following table to cross reference
your thin client model to the equivalent model to select under WSI 1.3.6 when "Adding"
or "Submitting" the new firmware into WSI. This is only for the Sx0 and Vx0 series.
Part Number
902110
902113
902114
902115
902122
902123
902124
902132
902134
902135
902136
QSG - WSI 1.3.6 v3.doc
U
SAGE
WSI Model
S12
S32
S52
S92
V32
V52
V92
V12
V32
V52
V92
Figure 11 - Completed WSI Add Image page
Part Number
902138
902139
902140
902141
902142
902143
902144
902146
902147
902148
WSI Model
V92
V32
V52
V92
V32
V52
V92
V32
V52
V92
Pager 10 of 15