Getting "File Not Found" Error Messages; Not Getting An Ip Address; Getting The Following Error: "Failure: Firmware Is Not Compatible; Becomes And Endless Loop - Wyse V90L Quick Start Manual

Wyse Customer Support
Problem 7:

Getting "File not found" error messages

Solution 7: Verify that your default FTP server address is set correctly using the IIS
Administration utility

Not getting an IP Address

Problem 8:
Solution 8: Verify that the "Database" section of DHCP Turbo does not exceed five (5) IP
Addresses. Otherwise just clear the displayed addresses and try again to
connect.
Problem 9:

Getting the following Error: "Failure: Firmware is not compatible"

Solution 9: Open the most recent log file in the
C:\INETPUB\FTPROOT\RAPPORT\TOOLS\SA\LOGS directory. Look for an
error message similar to
Evaluating: Unable to Open Source
(archive/ftp//anonymous:xxxx@10.1.1.12/Rapport/Wyse5S50\5150_128_WyseS505150/
5S50.i2d)
Verify the path of the file. In the case of the path for the example above, it
should be
What you may find is that the path is actually:
C:\Inetpub\ftproot\Rapport\Wyse5S50\5150_128_WyseS505150,NewVersion
Note that an invalid character such as a "," (comma) will cause the WSI to
truncate from that point on, giving you the above message.
Solution: Rename the path so that you remove the invalid character. You
can substitute the "," (comma) for an underscore
Problem 10: After re-imaging, the Thin Client reboots and starts the process again, and

becomes and endless loop.

Solution 10: Verify that the correct model was selected for the "Product" field when the
".i2d" file was added. See table on
with the appropriate model.
To verify this problem open the most recent log file in the
C:\INETPUB\FTPROOT\RAPPORT\TOOLS\SA\LOGS directory. Look for an
error message similar to:
Evaluating:
'ftp//anonymous:xxxx@10.1.1.12/Rapport/Tools/sa/9V90/push.k' to 'stream/sec/test'
Unable to Open Source
(ftp//anonymous:xxxx@10.1.1.12/Rapport/Tools/sa/9V90/push.k)
If you have a V90LE, the directory it's looking for should be "9V92".
Solution: Re-import the ".i2d" file using V92 as the product".
QSG - WSI 1.3.6 v3.doc
C:\inetpub\ftproot\rapport\Wyse5S50\5150_128_WyseS505150
.
page 10 and compare the part number
Pager 14 of 15