Table of Contents
Advertisement
.. To open the garage door, press the program-
med button. The LED® will light up or
flash.
.. To close the garage door, press the button
again.
@
Tips
To open the garage door, press the button,
but do not press it for longer ten seconds
or the Homelink module will switch to
programming mode.
Programming the transmitter
(version A)
App lies to vehicles : wit h Homelink a nd MMI
Fig. 137 Distance between the radiato r grille and the
hand tr ans mitter
You can program the fixed code and rolling
code systems using the described procedure.
Programming the button
.. Turn the ignition on .
.. There are two ways to program the button:
Press the button ¢ page 124, fig. 136 that
you would like to program. Use the instruc-
tions that appear in the MMI* to perform
the programming. Or
.. Select :
I
CAR I
function button >
Car systems*
control button
>
Vehicle settings> Garage
door opener> Program garage door open·
er.
If this path is not available, program
Homelink as described in version B
¢ page 126.
.. Select the button that you would like to pro -
gram.
.. Follow the instructions in the MMI*.
.. If the garage door opening must also be
synchronized with the Homelink module,
Homelink
125
refer to the owner's manual for the garage
door opener.
Remote control units for garage door openers
in Canada are set to stop transmitting radio
frequency signals after two seconds. This time
may not be sufficient for the Home Link sys-
tem to learn the radio frequency signal. Per-
form all other steps as described above.
Erasing/Clearing the programmed button
settings
.. To erase all of the programmed buttons at
the same time, select:
I
CAR !
function button
>
Car Systems*
control button
>
Vehicle set·
tings> Garage door opener > Clear pro·
gram settings> Yes.
The programmed but-
tons can not be erased individually . Repro-
gram the buttons if necessary .
.. Reprogram an individual button in the same
manner that you would for the one-time
programming .
Displaying the version/status/country
code
.. Select:
!CAR !
function button >
Car systems*
control button >
Vehicle settings > Garage
door opener > Version information .
(D
Tips
- Programming through the MMI* is not
possible with all infotainment systems .
If this is the case, program Homelink as
described in version B
¢
page 126 .
- The required distance between the hand
transmitter and the Homelink module in
the radiator grille ¢ fig. 137 depends on
the system that you are programming .
- Depending on the model of the garage
door opener, you may need to release the
button on the remote and press it again
when programming. When program-
ming a new device, keep the button
pressed for at least 15 seconds before
trying again with the transmitter in a dif-
ferent position. Watch out for the emer-
gency flasher during that time .
Advertisement
Table of Contents
