Advertisement
TK-1280E/-N180E/-1281EG
|
3. Adjusting
the
CCD
Vsus
Digital
TP-2
R14 (Vsus )
1. Connect a digital voltmeter to TP — 2.
adjustment
voltmeter
[IMEGER
[IMEGER board]
2. Set an imager-specified
voltage Vsus with
board]
R14 (Vsus ).
M@The
specified
voltage
is indicated
on
the
back of CCD.
See the box below : How
to compute
the specified
voltages.
RESET GATE | Oscilloscope
TP-3
R2 (RG)
1. Connect an oscilloscope to TP — 3.
adjustment
[IMEGER
{IMEGER board]
2. Set the reset gate pulse low level to an
board]
image-specified voltage VRGL with R2 (RG).
M@The specified voltage is indicated on the
back of CCD.
SEE the box below : How
to compute the specified voltages.
How
to compute
thespecified
voltages
Back of CCD
This indicates VRGL.
This indicates VSUB.
The mnemonics correspond to the actual values as follows :
vac mrorne] [2 [3 [«[s fe [7
jvsus mamone| | ¢{o[n |v [x [ulm{nfelalals|riulv[w]
x] | z |
PAcwat vate] 0fashoofoahah afzoj asad aspaohasf sobs eoheslnaf-spaolea
Example : "SL"means
VRGL = 3.0V and VSUB = 12.0V
14 (No. 6647)
Advertisement
