Advertisement
| TK-1280E/-1180E/-1281EG
3. Replacement of the CCD
Imager
(1) Follow Paragraph 2-2 or the removal of the chassis
(5) Remove the two screws © in Figure 4 and remove
mount
to remove
the chassis
mount.
the CCD holder, CCD
mask, and CCD imager.
(2) Remove
the two screws (J) shown
in Figure 4.
(6) After replacement, install a CCD imager with the hole
(3) Pull out the imager module
board in following the
on the back of it facing upward.
(See Figure 5.)
arrow
and
remove
it from
the
chassis
mount.
(4) Remove the two screws (K) in Figure 4 and remove
the
LPF
holder
and the low
— pass
filter.
LPF holder
Imager
insulator
TH
Chassis mount
wy
S
Q
CCD holder
Low pass Filter
Figure
4
Replacing
the CCD
imager
4 TOP
Back side
Figure 5
CCD direction
(No.6647) 7
Advertisement
