JVC TK-1280E Service Manual page 32

TK-1280E/-1N180E/-1281EG
2. Removal of Chassis Parts
* First remove the casing parts.
2— 1. Removing the top frame
(1) Remove the four screws (F) in Figure 2.
(2) Then the two PB holders will be removed at the
same time.
2— 2. Removing the chassis mount
(1) Remove the flexible wire in Figure 3. (Pull the
stopper in the direction of the arrows.)
(2) Remove the two screws (G) in Figure 2.
2— 3. Removing the rear terminal assembly
(1) Remove the two screws @)in Figure 2.
Figure 3 Removing the frexible wire
PB holder
2-4. Removing the bottom frame
(1) Remove the two screws (I)in Figure 2.
(2) Move the frame in the direction of the arrow and
remove it.
(3) The side shield will then be removed at the same
time.
2-5. Removing the module boards
(1) Remove the top frame and the side shield.
(2) Pull out each module upward and remove it.
Rear terminal assembly
Bottom frame
Figure 2 Removing the chassis parts
6 (No. 6647)