Advertisement
TK-1280E/-1180E/-1281EG
|
1. Presetting
6.
Chip VR
1) INT/EXT-U/L switch—>"
1 /E"
2) AGC switch
>" OFF"
3) White Balance switch >":#: "(in-door)
Point of contact
4) SHUTTER "NORM" (OFF)
5) BLC->" OFF"
2.
In holding a test pin with a probe, take care set contact with
any other pin. The CCD imager will be damaged if some text
pins are accidentally connected.
3.
EXT.TRIGGER
\n adjusting the signal system, extract the trigger signal as re-
Point of contact
Point of contact
5.
Repeat adjustments optimum conditions are established.
7.
No Adjustment of unspecified VRs
Never
rotate
VR's
other
than
those
specified
by
this
instruction Manual.
Advertisement
