Table of Contents
Advertisement
90
Homelin
k®
may not be sufficient for the Homelink ® sys-
tem to learn the radio frequency signal. Per-
form all other steps as described above.
Operating the Homelink ® transmitter
The HomeLink® transmitter works in the
some manner as the original hondheld re-
mote control that come with the system.
1------------------g:
g
N
:l',
:l!III
!
d ..
- ~
~
H ~
i: ...
Fig. 10 3
Overhead console: Homelink ® keypad
"" Press the appropriate programmed button
(D,
®
or @) to activate the des ired remote
control funct ion
c::>
&,
in General informa-
tion on page 88.
Reprogramming a single button
A HomeLink® button can be reprogrammed
individually without affecting the other but-
ton allocations.
Programming the overhead keypad
"" Press the app ropriate Homelink ® button
unt il the ind icator light begins flashing
slowly.
Programming the bumper mounted trans
mitter
1. Hold the
original remote control
at a dis-
tance between 0 - 5 in. (0- 13 cm) from the
bumper below the app ropriate head light
fo r your vehicle (use the shortest distance
possib le).
2 . Aim the remote control just below the
driver side head light .
3.
Press and hold the activation button on
the remote control.
4 . The emergency flashers will flash three
time s (afte r about 15-60 seconds) when
the programming is successful. Now re-
lease the button on the remote control.
"" If the dev ice utilizes a rolling code, please
follow phase 3 of
c::>
page 88, Programming
the HomeLink® transmitter
for rolling code
programm ing .
This procedure will cause the existing pro-
gramming on the Homelink ® button to be
erased!
Erasing the programming of the
Homelink ® transmitter
When you erase the programming, the pro-
gramming on all three of the transmitter
channels with be lost!
"" Perform steps 1 to 4 as described on
~
page 89, Phase 1: programming the over-
head keypad .
When completed, the Homelink ® system will
be in the prog ramm ing mode and is then
ready to learn the codes fo r remote controlled
devices.
©
Tips
- Programmed buttons ca nnot be erased
ind ividually .
- For security reasons you are adv ised to
erase the programming of the Home-
Link® sys t em before you se ll you r vehicle .
Advertisement
Table of Contents
