Advertisement
Available languages
Available languages
Electronic Ignition Lighting Instructions
▲ Do not lean over the grill while lighting.
1. Open the lid during lighting.
2. Turn ON the gas valve on the tank.
3. To ignite, turn the Main Burner knob to HI.
4. Push and hold the electronic ignition button.
5. If ignition does not occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes, and repeat
the lighting procedure.
6. To ignite another burner, repeat step 3.
7. Once burners are lit, adjust the knobs to the
desired flame setting. To extinguish an individual
burner, turn its knob to OFF.
8. To ignite the Searing Burner, follow steps 3-5 using
the Searing Burner knob.
If the igniter does not work, follow the Match Lighting
instructions below.
WARNING
Turn your controls, gas source or gas
cylinder OFF when not in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Match Lighting Instructions
▲ Do not lean over the grill while lighting.
1. Open the lid during lighting.
2. Place the match into the match holder (hanging on
the left of the side panel).
3. Light the match and insert the match holder through
the lighting hole in the left side of the firebox.
Align the lit match with the first burner on the left.
4. Turn the knob of the first left burner to HI position.
Be sure the burner lights and stays lit. Withdraw
the match holder from the firebox and extinguish
the match
5. To light the other burners, turn each knob in
succession to HI.
6. Once the burners are lit, adjust the knobs to the
desired flame setting. To extinguish any individual
burner, turn its knob to OFF.
Searing Burner Match Lighting
1. Open the searing burner lid. Turn on the LP tank.
2. Place the lit match near the burner.
3. Turn the side burner knob to HI. Be sure the burner
lights and stays lit.
Burner Flame Check
• Remove the cooking grates and heat diffusers. Light
the burners and rotate the knobs from HIGH to LOW.
You should see a smaller flame on the LOW setting
and a higher flame on the HI setting. Always check
the flame prior to each use. If only low flame is seen,
refer to the "Sudden drop or low flame" in the
Troubleshooting Section on page 32.
Turning Grill Off
• Turn all knobs to the OFF position. Turn the gas
cylinder off. When you are finished grilling, raise the
grill lid to allow the grill to fully cool. If the grill lid is
closed while the grill is cooling, condensation may
occur on the interior grill surfaces which can cause the
interior parts to rust.
Igniter Check
• Turn the gas cylinder off. Press and hold the electronic
igniter button. "Click" should be heard and sparks
should be seen each time between the collector box
or burner and electrode. See the Troubleshooting
Section on pages 31-33 if there are no clicks or
sparks.
Valve Check
• Important: Be sure the gas in the gas cylinder is
turned off before checking the valve and the knobs
are in the Off Setting. To check the valves, first push
in the knobs and release. The knobs should spring
back. If the knobs do not spring back, replace the
valve assembly before using the grill. Turn the knobs
to the LOW position then turn back to the OFF
position. Valves should turn smoothly.
Hose Check
• Before each use, check to see if hose is cut or worn.
Replace damaged hose before using the grill
9
Advertisement
