Burner Electrode and Igniter Cover
6
Place the 5 burner electrode wires (thin black & thin orange), the ground wire (red capped)
and the igniter wire (large black) through the pre-installed side panel clamp. (A)
Note: If wires are difficult to install, loosen the clamp screw, put the wires through the
clamp and retighten the screw.
Place the 4 thin black wires and 1 thin orange wire into the 5 slots in the electronic ignition
module. Place the red capped ground wire into the slot outlined in orange. Place the large
black wire into the wide slot. (B)
Attach the igniter cover with (2) M4x10 screws. (C) Note: If cover is hard to install, use a
screwdriver to press down on the right door heel hook to remove the door. Install the
cover and reattach door. (D)
M4x10 Screw
Qty: 2 pcs
A
C
24
B
D