Grill Head to Cart
5
IMPORTANT: Remove the tie wraps and packing material from the searing burner valve and
igniter wire. Pull the igniter wire out to the right side of the grill head.
This step requires two people to lift and to position the grill head onto the cart.
If not already done, remove the tie wrap and packing material from burner valve and igniter
wires located under control panel. Separate the 2 searing burner wires (round & straight
connection tip) from the other 7 wires (L- connection tip) shown in step 6. Keep the 7 wires
shown in step 6 beneath the grill head and inside the panel, and pull the 2 searing burner
wires out to the side of the grill head. (A)
Carefully lower the grill head onto the cart. Make the 2 searing burner wires are hanging
outside the cart. Attach the head to the cart with (4) M6x13 screws. (B)
M6x13 Screw
Qty: 4 pcs
A
Round Connection Tip
Straight Connection Tip
23
B
Pull these 2 searing
burner wires out to the
side of the grill head.