Sony DTC-87ES Operating Instructions Manual page 35

Various Playback Operations
Fade-in/fade-out play cannot be performed through the
digital output jack.
Fade-in Play
1 During playback or in the stop mode, press PAUSE.
The deck enters the pause mode.
2 Press FADER.
The FADE IN indicator blinks, and the sound fades in.
Fade-out Play
During playback, press FADER at the point where you
want to start fading out.
The FADE OUT indicator blinks, and the sound being
played back fades out.
A countdown starts, and the deck enters the pause mode
after the 0.0s indicator appears.
To designate a desired duration of fade-in/fade-out
You can designate a desired duration of fade-in/
fade-out, from 0.2 seconds to 15 seconds
Fade-in/fade-out is performed in 5 seconds unless
you designate a different duration.
If you turn off the unit after designating the desired
duration of fade-in/fade-out, the duration is reset to 5
seconds.
1 Choose either FADE IN orFADE OUT by pressing
FADER during the stop mode.
2 Designate a desired duration by pressing
<< or DP.
Each time pressing <4 or »®, a duration in the
display changes as follows:
from 0.2 sec. to 3.0 sec.: in 0.2 sec. intervals
from 3.0 sec. to 5.0 sec.: in 0.4 sec. intervals
from 5.0 sec. to 15 sec.: in 1 sec. intervals
Repeat Play
REPEAT
sem we aoe eas
jaeges:
[UI OA0M
Qq000
VALL aqqgeoa
jaagd &
acooqoa
aDnoas
asa
O00
Playing a Selection Repeatedly
Press REPEAT (1/ALL on the Remote Commander)
while the desired selection is played back.
"REPEAT 1" appears.
After the selection is playback, the tape is rewound to the
beginning of that selection, and the playback is repeated.
To stop playing a selection repeatedly
Press REPEAT (1/ALL on the Remote Commander) until
"REPEAT 1" goes off.
Note on the end of the repeated portion during
"REPEAT 1" play
The tape is rewound to the beginning of the selection to be
repeated when one of the following is detected.
@ Start ID of the next selection
A blank section of more than 9 seconds
End of the tape
Skip ID with SKIP PLAY activated
Number of times to be repeated
The selection to be repeated will be played back 16 times,
and then the tape will stop.
Playing all selections repeatedly
During playback, press REPEAT (1/ALL on the Remote
Commander) until! "REPEAT ALL" appears in the
display.
After the tape is played back to the end, it is rewound to the
beginning and the playback of all selections is repeated. In
the RMS play (page 39), all the selections programmed are
played back repeatedly. 5 5