Sony DTC-87ES Operating Instructions Manual page 30

When the skip ID is detected during playback, the tape
skips to the next start ID position, and the normal playback
resumes. (See page 24 for details.)
Writing During Recording
Press SKIP ID WRITE at the beginning of the
portion you want to skip later.
The skip ID is written for about 1 second (2 seconds
in the long-play mode) from where you pressed the
button,
utton ee Wee
_— skiP li
Lf NON S
es Lights momentarily.
Writing During Playback
During playback, skip ID can be written at the desired
position more accurately than during recording.
1 During playback, press SKIP ID WRITE at the desired
position.
The REHEARSAL indicator lights, and the portion for 3
seconds to the point where you pressed SKIP ID WRITE,
is played back repeatedly (rehearsal function).
The end of the repeated portion will be the beginning of the
skip ID.
2 Press << or »> to adjust the "repeat and" point.
The "repeat end" point shifted backward with «¢ or
forward with m&, by 0.3 of a second.
The indicator at the MARGIN shows how much the "repeat
end" point is shifted from the point where you pressed
SKIP ID WRITE.
It can be shifted up to 99 seconds backward or forward.
renearnsat «¢— Lights
When you pressed ~«#< twice
Note on the point where a skip ID is written
During rehearsal function, a skip ID will be written at the
end of the repeated portion as illustrated.
Point where you pressed
Repeated START ID WRITE
ortion | Skip ID (1second)
3 seconds : Each time you press >» ——>
a
Each time you press <<!
The repeated portion is played back 16 times, and the tape
stops.
etoiare]
During playback or in the stop mode, press Skip ID
ERASE immediately after the skip ID to be erased.
The tape is rewound to the nearest skip ID position and
the skip ID is erased.
The ERASE ID indicator lights while the skip ID is being
erased and goes off when the skip ID is erased.
Precaution
When the skip ID and the start ID are overwritten, the skip
ID will also be erased if the start ID is erased.
ID to be erased | Operation
3 After setting the beginning of the skip ID at the desired
point, press SKIP ID WRITE again.
The SKIP ID indicator lights, and the skip |D is written.
30
Start ID, skip ID | Press START ID ERASE. |
Skip ID | Press SKIP ID ERASE. |