Table of Contents
Advertisement
Operation
4
1
3
2
1
0
1
2
3
4
6
2
8
0
10
5
2
3
Machine Operation
Introduction
The tracer can work either in the tracer mode, using
a pattern or in the cutting mode for manual cutting.
Straight Line Cutting (without
template)
1.
Turn on Tracer/Control
2.
Select the Mode Switch to Strip
desired speed range
3.
Place the drive switch
and move the machine to the initial desired
position, using the Direction switch and the
Speed Control.
4.
Turn the drive switch to OFF when the initial
position is achieved.
5.
Set the Speed control to select the desired
cutting speed.
6.
Set the Direction Control
cutting direction.
7.
Place the plate to be cut in the cutting area and
make sure it is squared with the major axis of
the machine travel.
8.
Prepare the torches to be pre-heated.
9.
When the work is ready, place the Cut Oxy
switch in Manual.
10.
Place the drive switch ON.
11.
When everything is done, place the Cut Oxy
and Drive switches in OFF.
SECTION 4
1
and select
2
.
3
to the ON position
4
for the desired
5
1
Advertisement
Table of Contents
