Lost Cut Procedure - ESAB Silhouette 1000 Instruction Manual

Operation

Lost Cut Procedure

If the tracer loses the pattern edge while cutting, it
will be necessary to return the to the lost point and
resume cutting.
Losing the tracing is covered in the maintenance
section with other troubleshooting subjects.
Procedure:
1.
Retrace the pattern to the point of cut loss.
Use the speed dial to temporarily travel
faster to get to the lost point. Don't
forget to return to cutting speed!
2.
Using previously outlined procedures preheat
material to the proper temperature and
activate cut process.
SECTION 4