Assembly - Pro-Form PFTL62582 User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dis-
pose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver
1. With the help of a second person, carefully raise the
treadmill to the upright position. While a second person
tips the treadmill to one side slightly and holds it, insert
one of the Extension Legs (59) into the Base (32) as
shown. Make sure that the Extension Leg is turned so
the bracket is on top. Using the Allen Wrench (102),
tighten an Extension Leg Screws (57) into the Base and
the Extension Leg. Next, tip the treadmill to the other
side and attach the other Extension Leg in the same way.
With the help of a second person, carefully lower the
treadmill so that both Extension Legs (59) are resting
flat on the floor.
2. Refer to HOW TO LOWER THE TREADMILL FOR
USE on page 11. Follow the instructions in step 2 to
lower the treadmill.
Without removing the tape from the Latch (34), hold the
Latch against the left Upright (32) as shown. Attach the
Latch to the left Upright with four shorter Screws (33).
Make sure that the Screws are tight, but do not
overtighten them; if the Screws are overtightened,
the Latch will not slide smoothly. After the Latch is
attached, remove any visible tape.
Note: The inset drawing shows how the parts of the
Latch (34) fit together.
3. Cut the plastic tie holding the cage nut in the upper end
of the Left Handrail (60).
Position the Left Handrail (60) on the left Upright (32) as
shown. The bracket on the Extension Leg (59) should
be inside of the lower end of the Left Handrail. Thread
a Handrail Bolt (30) with a Handrail Washer (31) into the
left Upright and the Left Handrail. Do not tighten the
Handrail Bolt yet.
, adjustable wrench
1
102
2
32
34
33
33
3
5
, and scissors
32
57
Bracket
Spacer
Bracket
30
31
32
59
.
59
Springs
Latch
60