Spa Pool Care & Maintenance; Opening The Panels - Alpine ELITE CALGARY Owner's Manual

8. SPA POOL CARE & MAINTENANCE

OPENING THE PANELS

OPENING THE SPA POOL PANELS IS A WARRANTY
REQUIREMENT.
Your spa pool contains high performance parts that are regularly put under
pressure and exposed to various water conditions controlled by the user. As part
of your warranty requirements, your spa pool requires periodic checking of the
components inside, just like how a car requires the bonnet opened to check oil.
The inspection is rather simple and should take no longer than 10 minutes.
See pages 52-54 to understand what to check for.
Vertical Slat
Left Panel
Vertical Slat
Each side of the spa pool consists of two cabinet panels, left and right. Holding
these panels onto the frame of the spa pool are three vertical slats with 3 screws
per piece. Note: Front panel may have an LED logo which two small LED lights
connect into from the back. Take care when removing the front panel and simply
pull the LED lights out of their sockets to disconnect.
To remove the panels:
1. Start by unscrewing the vertical slats from one side. (Phillips size3 bit is best).
2. Unscrew the 3 screws in the middle slat to release one panel at a time.
3. The panels should come away from the cabinet, if not, push down and/or pull
towards you.
4. Reverse the steps to replace the panels.
42
42
Right Panel
Vertical Slat