Alpine ELITE CALGARY Owner's Manual page 22

6. SPA POOL USAGE GUIDE & TIPS
Filter Cycles
A filter cycle is a period in which the circulation pump is run for a user programmed
length of time. This allows for a dedicated period of water sanitising and clean up.
Heavier spa pool usage may require longer filter cycle times. At the start of each
filter cycle, the main jet pump may run briefly to purge the plumbing.
Filter cycle operation consists of two separate programmable parameters:
- Duration of filtration per day [FILT] (hours per day, e.g. 4 hours total per day)
- Filter cycle blocks [F.CYC] runtime divided into cycles every 1/2/3/4/6/8/12 or 24
hrs (default=3)
The default settings are: 4 hours of filtration per day over 4 individual 1-hour filter
blocks (e.g. every 4 hours, an hour long filter cycle will engage.)
Setting Filter Cycle Hours of Filtration [FILT]
Press the
Press the FILT menu item to adjust, you may need to use the
button to scroll up and down. Change the filtration using the or
button. Then press the
Setting Filter Cycle Blocks [F.CYC]:
Press the
Press the F.CYC menu item to adjust, you may need to use the
button to scroll up and down. Change the filter blocks using the
button. Then press the
Sleep Timers [SNZE]
Sleep timers are a very handy feature which enables the user to stop all spa pool
activity during certain times of day or night. While the controller is in sleep mode
NO automatic heating or filtration maintenance will occur, however the spa pool
can still be operated by manual use without the need to adjust sleep time settings.
There are two individual sleep timers that can be set, each of which can operate on
one or more specified weekdays. This enables the user to program different sleep
times for different days (i.e. weekdays vs weekends), as well as customizing the
settings on a particular day/time where the user may want the spa pool silenced.
Default Sleep Timer Settings: Sleep Timer 1 (Sat – Fri; Sleep period 22:00 – 07:00).
22
22
button
button to confirm. (Default = 4 hours)
button
button to confirm. (Default = 3)
or
or
or