Table of Contents
Advertisement
DIAGRAM OF THE CONSOLE
Y'_
--
Clip
Mode
IIIIIIIIIIIII
---\
Speed Control
\
_'Note:
If there is a thin shee
\
of clear plastic on the face of
the console, remove it.
8
STEP BY STEP CONSOLE OPERATION
The treadmill console features a manual mode and six
preset workout programs. In the manual mode, the
speed of the walking belt can be changed with the elec-
tronic speed control. When one of the workout programs
is selected, the console will automatically control the
speed as it guides you through an effective workout.
console, make sure
"On"
that the on/off switch
Position
near the power cord
is in the "on" position.
If the key is in the console, remove it. Make sure that
the power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.)
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing above), and
slide the clip onto the waistband of your clothing.
Follow the steps below to operate the console:
g
Insert the key fully into the power switch.
The four displays
r-
and the green MAN-
/
UAL mode indicator
will light.
L._ ..J
_'_ Reset the speed control and select a speed
setting.
Slide the speed control down to
the "RESET" position..Note.-
Each time the walking belt ls
stooped, the soeed control
must be moved to the
"RESET" oosltlon before the
walkina belt can be restarted.
H
_L
I
II
Next, slide the speed control
upward to select a speed set-
ting. Note: If the key was just
Inserted, or if the walking belt
was stopped with the
START/STOP button, the
walking belt will not begin to move yet.
-1(:::===:31.
2r, rtm
Advertisement
Table of Contents
