The Imager Won't Read Your Bar Code At All; Quick Reference Guide - Wasp 2D Quick Reference Manual

The Imager won't read your bar code at all.

1. Scan the part number bar code in the back of this manual or the
samples from the Product Reference Guide. If the Imager reads
sample bar codes, check that your bar code is readable.
Verify that your bar code symbology is enabled (see the Product
Reference Guide).
2. If the Imager still can't read the sample bar codes, scan the "All
Symbologies" setting from the Product Reference Guide.
If you aren't sure what programming options have been set in the Imager,
or if you want the factory default settings restored, scan "Standard Prod-
uct Default Settings" from

Quick Reference Guide

.
Page 1-7
Troubleshooting
2-5