Appliance Installation - Thermador PH30 Installation Instructions Manual

CAUTION:
Vent unit to outside of building, only.
The hood can be mounted on a wall or suspended
from a cabinet. Both vertical and horizontal discharge
are possible with either mounting method.
Discharge Direction: The hood is shipped ready for
vertical discharge. To change to horizontal discharge
move the discharge cover shown in Figure 1a to the
top of the hood. The plate is held in place by 4 (four)
screws.
This opening is
covered for
horizontal
discharge
Figure 1a: Discharge Direction
Figure 1b: Overall Dimensions

Appliance Installation

Assembly of the Transition: The supplied
transition mounts to the top or rear of the hood
depending on the discharge direction.
1. Align mounting holes at base of transition with
2. Fasten transition to hood using two (2) # 8
3. Seal connection between transition and hood
4. Remove tape holding damper closed.
See Figure 1b for overall hood dimensions.
4
mounting holes on 1/2" flange located at the top
or rear of the hood depending on direction of
discharge.
sheetmetal screws (included with hood).
with duct tape.
This opening is
covered for vertical
discharge.
30", 36", 42", 48", 54" *
18"
27"
* Varies by model.