Table of Contents
Advertisement
EP803S ASSEMBLY
1. LEG ASSEMBLY
Body
700~750 mm
1)
First, place the body on a stand with a height of ap-
proximately 700 mm.
Hexagonal bolt
Wrench
2)
Use the hexagonal bolts provided to attach the rear
leg (the longer one).
Two MI2 x 40
hexagonal bolts
Four MI2 x 50
hexagonal bolts
3)
Next, attach the front legs.
The rear leg is longer than the front ones; however,
take note of the fact that the bolts used to attach it
are shorter than those used to attach the front legs.
Both front legs are of equal length and may be at-
tached on either side.
2. PEDAL ASSEMBLY (EP308S only)
1)
Grasp the pedal and the pedal wire as shown in the
figure and, bending the wire, insert the lifting rod
into the hole in the bottom of the body.
Align the bracket —
M4 x 25 screws used for
attaching the lifting rod
—
Underside of the body
(Key bed)
2)
Next, use a Phillips screwdriver to install the M4 x
25 oval countersunk Phillips-head screws which fas-
ten the lifting rod.
[e]
pemen
FES
—— —
|
D
D
NOTE:
SS
te
Be careful to ensure that the screws are properly aligned
` before tightening them, since their threads are possibly
stripped if they are cross-threaded.
Advertisement
Table of Contents
