Sony SRS-XV500 Help Manual page 62

Help Guide
Wireless Speaker
SRS-XV500
Listening to music wirelessly with 2 speakers (Stereo Pair function)
To use the Stereo Pair function, 2 SRS-XV500 speakers are required. By connecting 2 speakers via a BLUETOOTH
connection, you can enjoy more powerful sound.
2 speakers connected via a BLUETOOTH connection play sounds in stereo, where 1 speaker plays the sound on the
right channel (right side) and the other plays the sound on the left channel (left side).
Before operating the speaker, make sure of the following:
Update the pre-installed software to the latest version on each and every speaker to connect for the function.
(For details about the update procedure, see
When setting up the speakers for the Stereo Pair function, make sure that the 2 speakers to connect for the function
are located within 1 m (3.2 ft) from each other. Stop music playback if it is in progress.
When playing music, make sure that all of the devices to connect for the function are located within 30 m (98.4 ft) in
your line of sight.
Maximum communication range may shorten under the following conditions.
There is an obstacle such as a person, metal, or wall between the speaker and BLUETOOTH device.
A wireless LAN device is in use near the speaker.
A microwave oven is in use near the speaker.
A device that generates electromagnetic radiation is in use near the speaker.
Use "Sony | Music Center" to set up the speaker for the Stereo Pair function.
1
For details about "Sony | Music Center," refer to the following URL:
https://www.sony.net/smcqa/
To terminate the Stereo Pair function
Use "Sony | Music Center."
Hint
Use of the Stereo Pair function automatically switches the codec to SBC.
Turning off the speakers does not turn off the Stereo Pair function. When one of the speakers is turned back on, it attempts to
establish a connection for the Stereo Pair function. To use the Stereo Pair function, turn on the other speaker within 1 minute.
When the BLUETOOTH standby function remains active
automatically turns on the other and establish a connection for the Stereo Pair function between the speakers.
* The BLUETOOTH standby function is activated only while the speaker is connected to an AC outlet by the supplied AC power cord (mains
lead).
Note
While the Stereo Pair function is in use, the speaker is not capable of outputting the music playing on the USB device that is
connected to the PLAY/CHARGE OUTPUT port (USB) or on the device that is connected to the AUDIO IN jack by an audio cable.
While the speaker is in AUDIO IN or USB mode, you can set it up for the Stereo Pair function with "Sony | Music Center" as well.
Upon completion of the setup, however, the speaker is automatically placed into BLUETOOTH mode.
Updating the pre-installed
*
on both of the speakers, however, turning on either of the speakers
62
software.)