Warning - Kenwood KRC-603C Instruction Manual

Basic operations of remote
(See page 8)
Function of the KRC-603C/ 503, Optional for the KRC-403
| ACAUTIOW
Do not set the remote on hot places such as above the dash¬
board.
Replacing the Lithium Battery:
Use one lithium battery (CR2025).
Remove the case following the instructions as illustrated.
To open
© Keep on slide
© Pull out.
Insert the battery with the + and — poles aligned properly, fol¬
lowing the illustration inside the case.
^warning"
Store unused lithium batteries out of the reach of children.
Contact a doctor immediately if the battery is accidentally swal¬
lowed.
Tuner Mode
• Number buttons
Press buttons #1-6 to recall preset stations.
During direct access tuning, use these buttons to input the fre¬
quency of the station.
• TUNE buttons
Press the TUNE — button to decrease the frequency.
Press the TUNE + button to increase the frequency.
• AM/FM button
Press the AM button to select the AM band.
Press the FM button to select and switch between FM1, FM2,
and FM3 bands.
• DIRECT button
Selects the direct access tuning mode, used to input frequen¬
cies directly. Press this button again to cancel the mode while it
is operating.
All Modes
• VOL. buttons
Press the button to turn the volume up.
Press the button to turn the volume down
• TUNER button
Selects the tuner mode. Pressing this button again selects the
standby mode.
• TAPE button
Selects the tape mode.
• CD*MD CH button
Selects the disc changer mode
Tape Mode
• T.ADV («◄/►►<) buttons
Press the button to start play again at the beginning of the
current track
Press the button to start play at the beginning of the next
tra'
y
•
REW button
Rewinds the tape
• FF button
hast forwards the tape
• PROG button
Plays me re., - -.e vde of the tape When pressed during fast for
ward a- d (e.\ ■ l !f e> button stops the tape and starts playing it
10