Table of Contents
Advertisement
UtNISTALLATilON
STEP
7
Install
the
Battery
Backup
-
Make sure motor unit is unplugged.
•
Using a Phillips head screwdriver,
remove the battery
cover on the motor unit.,
•
Partially
insert battery into motor unit with terminals
facing out.
•
Connect the red (+) and black (-) wires from motor unit
to corresponding
terminals
on battery.
•
Replace
battery cover.,
;:i;::i i :::i:::i _::b':::: ¸
....
ALWAYSwear protective gtovesand eyeprotection when
changingthe battery or working around the battery
compartment.
Batten]
Battery Cover
gNSTALLATIION
STEP
8
Nnstali
the
Lights
• Press the release tabs on both sides of lens.. Gently
rotate lens back and downward until the lens hinge is in
the fully open position.. Do not remove the lens..
• Install a 100 watt maximum light bulb in each socket.
Light bulb size should be A19, standard neck only., The
lights wilt turn ON and remain lit for approximately
4-1/2 minutes when power is connected_ Then the lights
will turn OFF,.
° Reverse the procedure to close the lens.,
o Llse A19, standard neck garage door opener bulbs for
replacement,
NOTE: Use only standard light bulbs,. The use of short
neck or speciality light bulbs may overheat the endpanel
or light socket°
To preventpossible OVERHEATING o f the endpanelor light
socket:
o DONOTuseshort neck or specialtylight bulbs,.
• DONOTuse halogenbulbs,,Use ONLYincandescent,
To preventdamageto the opener:
• DONOTusebulbs largerthan IOOW.
• ONLYuseA19 size bulbs
!oo Watt (Max)
Standard Light Bul_
/
Release Tab
I
1O0 Walt (Max)
Hinge
Standard Ught Bulb
18
Advertisement
Table of Contents
