Program The Travel Limits - Chamberlain WhisperDrive WD962KD Owner's Manual

ADJUSTMENT STEP 1
Program the Travel Limits
Travel limits regulate the points at which the door will
stop when moving up or down. Follow the steps below
to set the limits.
To program the travel limits:
Figure 1
° o
tndic_tor Ught
- Black Buttot_
- PurpleBlJtlon
Adjust the position of the door by using the black and
purple buttons.. Black moves the door UP (open) and
purple moves the door DOWN (close).
1..Setting the UP position: Press and hold the black
button until the yellow indicator light starts flashing
slowly then release,,
2oPush and hold the bIack button untit the door reaches
the desired UP (open) position (Figure 2)..
NOTE: Check to be sure the door opens high enough for
your vehicle..
3oPush the remote control or door control (Figure 3). This
sets the UP (open) limit and begins closing the door,.
4..Immediately when the door begins to move down, press
and release either the black or purple button.. This will
stop the door..
5 Setting the DOWN position: Push and hold the purple
button until the door reaches the desired DOWN
(closed) position (Figure 4),
6..Once the door is closed, if there appears to have too
much pressure on the door, you may toggle the door
back and forth using the black and purple buttons to
reach the desired closed position.
7, Push the remote control or the door control (Figure 3)7
This sets the DOWN (close) limit and should bring the
door to the open position,,
- If the opener is not stopping exactly where you
would like it, repeat steps 1 through 7 and program
the limitsagain.
= When the unit stops in both the desired up (open)
and down (close) positions, proceed to
Adjustment Step 2, Setting the Force..
Without a properly installed safety reversalsystem, persons
(particularlysmall children) could be SERIOUSLY INJURED or
KILLEDby a closing garagedoor.
° Incorrect adjustmentof garagedoor travel limits will interfere
with proper operationof safetyreversal system,
=NEVER useforce adjustmentsto compensate for a binding or
sticking garagedoor_l
• After ANYadjustmentsare made, the safety reversalsystem
MUSTbe tested. Door MUSTreverseon contact with 1-1/2"
(3 8 cm) high object (or 2x4 laid flat) on floor,.
To preventdamageto vehicles,be sure fully opendoor
providesadequateclearance,
Indicator Ught
Figure 2
Push and hold
" until the door
is at desired UP
posilion
Figure 3
OR
Figure 4
Indicator Ught
Push either ._
button toslop _,*-_.
door a ,desired ll_l
DOWN position [J---_-- U
28