Table of Contents
Advertisement
18
Connect Power
There is only one option for connecting power:
TYPICAL WIRING
Plug in the garage door opener into a grounded outlet.
19
Install the Battery Backup
To reduce the risk of FIRE or INJURY to persons. Disconnect ALL electric and battery power BEFORE performing ANY
may explode. Check with local codes for disposal instructions.
When in Battery Backup mode, MyQ Smartphone Control and wireless MyQ devices will be disabled. In battery backup
mode, the automatic garage door lock will unlock when the garage door is opened, and will remain disabled until power is
restored.
1. Unplug the garage door opener.
2. Use screwdriver to remove the battery cover on the garage door opener.
3. Partially insert the battery into the battery compartment with the terminals facing out.
4. Connect red (+) and black (-) wires from the garage door opener to the corresponding terminals on the battery.
5. Replace the battery cover.
6. Plug in the garage door opener.
BATTERY STATUS LED (B)
GREEN LED:
All systems are normal.
•
A solid green LED light indicates the battery is fully charged.
•
ORANGE LED:
The garage door opener has lost power and is in battery backup mode.
•
A solid orange LED with beep, sounding approximately every 2 seconds, indicates the garage door opener is operating on battery power.
•
RED LED:
The garage door opener's 12V battery needs to be replaced.
•
A solid red LED with beep, sounding every 30 seconds, indicates the 12V battery will no longer hold a charge and needs to be replaced.
Replace the battery back up to maintain the battery backup feature.
NOTE: Battery does not have to be fully charged to operate the garage door opener.
(Optional accessory)
9 / en
Advertisement
Table of Contents
