VTech TeleZapper VT2558 Operating Instructions Manual page 23

You Hear Noise In The Handset, And None Of The Keys Or Buttons Work
• Make sure the power cord is plugged in.
The ANSWER ON/OFF Button is Blinking
• If the button flickers on and off, you need to reset the day and time. See
Answering System Setup -Checking and Setting Day and Time for details.
• If the button slowly flashes, it indicates the answering system is in Announce Only
mode. See Answering System Setup -Set Announce Only for details.
Common Cure For Electronic Equipment
If the unit does not seem to be responding normally, then try putting the Handset in the
cradle. If it does not seem to respond, do the following(in the order listed) :
1. Disconnect the power to the Base.
2. Disconnect the Handset battery.
3. Wait a few minutes.
4. Connect power to the Base.
5. Re-install the battery pack, and return the Handset to the charge cradle.
6. After a few seconds, try using your Handset again.
In Case Of Difficulty
23