Siemens SICHARGE D Product Information page 87

Removing the rope stopping mechanism
The following operating instruction shows how to remove the rope stopping mechanism of the right charging point of the
charging station. The procedure for the left charging point is identical.
Figure 14 Removing the rope stopping mechanism
NOTICE
Danger of crushing by rope box
The rope is tensioned by a spring tension mechanism in the rope box. Avoid crushing and burning. Pull the cable down on the
cable clamp until the rope clamp is relieved. This allows you to remove the rope clamp on the cable box without the risk of
injury.
Pull the cable at the cable clamp only until the rope clamp is relieved and free. If you pull too far, the rope clamp may damage
the pulleys in the pulley cross. Remove the rope stopping mechanism with an 8 mm socket. Remove the pulley.
Note
Store aside rope clamp and pulley
If a repair is required – on the cable clamp or the charging cable for example – then you must secure the rope on the rope box.
Therefore, keep the rope clamp and pulley in a DIN A4 envelope in the document pocket of the charging station.
Installation of the cable management system
A5E53160522-AA, 11/2023
Installing the cable management
87