Connect To Ac Mains; Startup Procedure - Crown CTs 4200 Operation Manual

3 Setup
page 10

3.7 Connect to AC Mains

Connect your amplifier to the AC mains power
source (power outlet) with the supplied AC power
cordset. First, connect the IEC end of the cordset to
the IEC connector on the amplifier; then, plug the
other end of the cordset to the AC mains.
WARNING: The third prong of this connector
(ground) is an important safety feature. Do
not attempt to disable this ground connec-
tion by using an adapter or other methods.
Amplifiers don't create energy. The AC mains volt-
age and current must be sufficient to deliver the
power you expect. If the AC line voltage varies out
of an acceptable range, the amplifier's power supply
turns off and the blue Power LED flashes. The
amplifier will turn back on when the AC line voltage
returns to safe operating levels. Figure 3.10 pro-
vides voltage limits for all amplifier AC voltage con-
figurations. Also, the amplifier must be run within
the specified mains frequency requirements (indi-
cated on the amplifier's back panel label). If you are
unsure of the output voltage of your AC mains,
please consult your electrician.
Under-Voltage Over-Voltage
Models
Limit Limit
100VAC
90VAC 110VAC
(CTs 8200
only)
120 VAC units 108VAC 132VAC
220V/230V/
198VAC 264VAC
240V units
Figure 3.10 AC Under-Voltage and Over-Voltage
Limits for Various Amplifier Models

3.8 Startup Procedure

Use the following procedure when first turning on
your amplifier:
1. Turn down the level of your audio source.
2. Turn down the level controls of the amplifier.
3. Turn on the "Power" switch. The Power indica-
tor should glow.
4. Turn up the level of your audio source to an
optimum level.
5. Turn up the Level controls on the amplifier until
the desired loudness or power level is
achieved.
6. Turn down the level of your audio source to its
normal range.
If you ever need to make any wiring or installation
changes, don't forget to disconnect the power cord.
For help with determining your system's optimum
gain structure (signal levels) please refer to the
Crown Amplifier Application Guide, available online
at www.crownaudio.com.
CTs Multi-Channel Power Amplifiers
Operation Manual