Handset Locator; Handset Speakerphone Operation; Line In Use Indication; Conference Calling - VTech i5867 Operating Instructions Manual

Handset Operation
Handset Locator (from Base):
Press the PAGE button from the Base Unit to page all Handsets. Each Handset will beep
for 20 seconds to alert you to their locations. To stop the beeping, press ON or any dial pad
button on the Handset, or PAGE on the Base Unit.

Handset Speakerphone Operation

Your i 5867 Handset has a built-in handsfree speakerphone. This feature allows you to
stand the Handset upright on a table or desktop and have handsfree conversations. For
more information, refer to Making Calls in the Handset Operation section.

Line in Use Indication

When the telephone line is currently being used
by a i 5867 system Handset, a status message
similar to this will display on idle Handset(s):
When the telephone line is currently being used
another phone (other than an i 5867 system
Handset), the phone icon will remain on steadily,
and EXTENSION IN USE will be displayed:

Conference Calling

The i 5867 is capable of supporting conference calls with up to two registered Hand-
sets. To enter a conference call, simply access the line with two extensions by press-
ing ON (or SPEAKERPHONE) on the Handset. The phone icon
numbers will be displayed in the upper left corner of the Handset display.

Transferring Calls

You can transfer calls with the i 5867 system from Handset to Handset.

Blind Transfer:

You can directly transfer any active call to another i 5867 extension without notification
by following these steps:
• Press the middle NavKey then press the up or down NavKey to the desired location.
• Press the middle NavKey to confirm.
• The ringing Handset can pick up the transferred call like a regular incoming call.

Announced Transfer:

You can perform an announced transfer (call and advise another extension) of an
active call by following these steps:
• Press HOLD to place your call on hold.
• Press any NavKey then press the left NavKey to select Intercom, press the middle
Navkey in again to confirm.
-OR-
Press any NavKey then press the 1 key.
• Press the up or down NavKey to the desired location.
• Press the middle NavKey to confirm.
• When the ringing Handset answers, announce that there's an active call on hold.
• Press OFF on either handset.
• Press ON (on the destination Handset) to pick up the call on hold.
30
and two extension