Bit Switches - 5; Ip Fax Switches - Ricoh M15 Field Service Manual

4. Service Tables
Bit Switches – 5
• Do not adjust a bit switch or use a setting that is described as "Not used", as this may cause the
machine to malfunction or to operate in a manner that is not accepted by local regulations. Such
bits are for use only in other areas, such as Japan.
Default settings for bit switches are not listed in this manual. Refer to the System Parameter List printed by
the machine.

IP Fax Switches

No.
0 Not used
IP Fax Transport
1
0: TCP, 1: UDP
IP Fax single port selection
2
0: OFF, 1: ON (enable)
IP Fax double ports (single data port)
selection
3
0: OFF, 1: ON (enable)
IP Fax Gatekeeper
4
0: OFF, 1: ON (enable)
IP Fax T30 bit signal reverse
5
0: LSB first, 1: MSB first
IP Fax max bit rate setting
0: Not affected, 1: Affected
6
116
IP Fax Switch 00 (SP No. 1-111-001)
Function Comments
Do not change this setting.
Selects TCP or UDP protocol for IP-Fax
Selects single data port.
Selects whether IP-Fax uses a double port.
Enables/disables the gatekeeper for IP-Fax.
Reverses the T30 bit signal.
When "0" is selected, the max bit rate does not
affect the value of the DIS/DCS.
When "1" is selected, the max bit rate affects the
value of the DIS/DCS.