Panasonic NV-DS99EN Operating Instructions Manual page 28

mm)
1
m
[power]imiffliaEft
wcRimmm)
•
- H*j»aMM>IIS[VCR] •
2
[**]
a.
• W»R*HWSWSB5!Sffl#i«S •
•£*K*sujanw4 ■ wiuffjhe)®.
3 SfifiR [►] • M5SS5IJO
4 (SitSSJBR:
SffJtma*
Viewing the Just Recorded Scenes on
the Movie Camera
(Playback)
You can play back recorded scenes right after recording.
1 Set the [POWER] Switch to [VCR].
•While pressing the centre button, slide the switch to
[VCR].
c.
Press the Rewind Button [◄◄] to rewind the
tape.
• Rewind the tape to the point where the recording was
started.
•If the tape reaches the beginning, rewinding
automatically stops.
O Press the Play Button [►] to start playback.
4 To stop playback:
Press the Stop Button [■].
■ mmmm
&ft[PUSH]^0 . SStiJIjt[VOLUME]JS^© =
m.'&
- ffU
[PUSH]^ * £[PUSH]I£ • {£(VOLUME]
A
°
- a(T]5JJ[W]fi - ffi[VOLUME]Jg^ffim • f*
m ' [VOLUME]•
•
m
-
•
Xmmmm&im
. •
g
mmm
a .
mm
- -
* Rj5lA[VCR FUNCTIONS]±^Uc[CAMERA
FUNCTIONS]±mm > ^[DISPLAYSETUP]^Kim±^[DATE/TIME(B
m
/ •
> tfeTOjffiajS*gc«lJSlSa±W[DATE/nME(B«l/l^l1l!)]
■ Adjusting the Sound Volume
Keep the [PUSH] Dial O pressed until the [VOLUME]
Indication 0 appears. Then, turn the [PUSH] Dial to adjust the
volume. After adjusting, press the [PUSH] Dial to make the
[VOLUME] Indication disappear.
To adjust the volume with the Remote Controller, press the [T]
or [W] Button to make the [VOLUME] Indication appear. You
can then increase the volume by pressing the [T] Button or
decrease it by pressing the [W] Button. A few seconds after
finishing the adjustment, the [VOLUME] Indication disappears.
•Only the volume of the sound from the Movie Camera's built-
in speaker can be adjusted.
•When using the Playback Zoom Function, it is not possible to
adjust the sound volume.
Making the Date/Time Indication Appear
This Movie Camera automatically records the date and time,
however not directly in the picture but as part of the sub code
("♦ 96).
To make the Date/Time Indication appear, set [DATE/TIME] on
the [DISPLAY SETUP] Sub-Menu of the [VCR FUNCTIONS]
or the [CAMERA FUNCTIONS] Main-Menu to the desired
setting.
It is also possible to make the Date/Time indication appear and
change it by repeatedly pressing the [DATE/TIME] Button on
the Remote Controller.
_OQ