Supplying Power With The Battery - Panasonic NV-DS99EN Operating Instructions Manual

ENGLISH
■ Supplying Power with the Battery
Before use, charge the Battery.
I SHtBHrat ■
- «&?]<
¥»» ■ ■smsitait «
t assiie^±M[ioo%]?E®'®^®B.
rnmim
■>
EPft£/HE$S&a&±tfjft^(80% • ioo%)3MSE?EVI*to
tt&mis.
<•
- [quick]
l
i wfifi^ioi»■
mm
as«
i
mmwmzmmm
* ncmftsftauui.
i KmSASIieii±n«»S - 3£[q]T^iJ -
ER»ii-wraitt •
-£®ft[BATT.EJECT PUSH](m»tb)£fi<T) •
:t±i •
[POWER][OFF] •
1 Place the Battery on the AC Adaptor as shown
above and slide it horizontally until it stops.
2
Connect the AC Mains Lead to the AC Adaptor
and to an AC mains socket.
3
When the [100%] Lamp on the AC Adaptor is lit,
charging is finished.
When the [QUICK] Lamp is lit, approximately 1 hour of
continuous recording is possible.
The figures (80%, 100%) printed on the AC Adaptor
indicate approximate charge reached.
•The [QUICK] Lamp flashes and then remains lit only when
charging a quick-charge type battery. The Battery supplied
with this Movie Camera is not of the quick-charge type.
•Charging is not possible when the DC Input Lead is
connected to the AC Adaptor.
4
Remove the Battery by sliding it in the opposite
direction of Step 1 above.
Also disconnect the AC Mains Lead.
5
Slide the Finder backward to its fully extended
position and then tilt it upward.
6 Insert the Battery into the Battery Holder on the
Movie Camera and slide it downward until it
locks with a click.
Removing the Battery from the Movie Camera
While pressing the [BAIT.EJECT PUSH] Button ©, slide the
Battery upward to remove it.
• Be careful not to drop the Battery by accident.
• Before removing the Battery, set the [POWER] Switch to
[OFF].
.11.