Complete Installation; Reversing Dryer Door Swing (Optional) - Maytag MLG22PRTKW Installation Instructions Manual

COMPLETE INSTALLATION

1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended earthing method.
See "Electrical Requirements. "
2. Check that all parts are now installed. If there is an extra part,
go back through the steps.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
7. To test and to clean your washer, measure one-half the
detergent manufacturer's recommended amount of High
Efficiency (HE) detergent for a medium-sized load. Pour the
detergent into the detergent dispenser. Select any cycle and
allow the washer to complete one whole cycle.

REVERSING DRYER DOOR SWING (OPTIONAL)

Remove the Door Assembly
1. Place a towel or soft cloth on top of dryer or work space
to avoid scratching of the surface.
2. Remove three of the four screws that hold the door hinge on the
front panel of the dryer. Partially loosen the remaining screw with
keyhole opening and lift the door off the screw.
8. Check dryer operation. Using a full heat cycle, let the dryer run
for at least 5 minutes. Dryer will stop when time is used up.
NOTE: The dryer door must be closed for the dryer to operate.
When the door is open, the dryer stops, but the timer continues
to run. To restart the dryer, close the door and press the cycle
button.
If the burner does not ignite and you can feel no heat inside
the dryer, shut off dryer for 5 minutes. Check that all supply
valve controls are in On position and that the electrical cord
is plugged in. Repeat the 5 minute test.
3. Lay the door assembly on a previously prepared flat surface
with the inside (inner door assembly) facing up, and remove six
Phillips-head screws to release outer door assembly from inner
door assembly.
NOTE: It is important that you remove only the six indicated
screws.
21