Table of Contents
Advertisement
Available languages
Available languages
Replace Oven Bake Burner Cover
1.
Align rear shoulder screw mounting holes (keyholes) on the
oven bake burner cover with shoulder screws in the bottom
of the oven.
4.
Using a T15 Torx® screwdriver, remove the burner base.
Large Dual Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
Medium Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
Small Burner
A. Burner cap
B. Gas opening
C. Burner base
5.
Apply masking tape to the end of a 7 mm
nut driver to help
hold the gas orifice spud in the nut driver while changing it.
A. Shoulder screw mounting holes (keyholes)
Insert nut driver into the gas opening and press down onto
B. Shoulder screws
the gas orifice spud and remove by turning the gas orifice
spud counterclockwise and lifting out. Set gas orifice spud
2.
Drop cover and slide to left or right to slide shoulder screws
aside.
into narrow ends of keyholes and lock in place.
6.
Replace with correct Natural gas orifice spud. See the
"Natural Gas Orifice Spud/Hood Chart."
Use the following chart to find the exact orifice spud
placement.
Natural Gas Orifice Spud/Hood Chart
Burner Rating
Size
Burner Style
5,000 BTU
1.01 mm
Small burners
rT
rT
i
ZN
15,000 BTU
1.75mm
Medium
burners
A. Bake burner cover
20,000 BTU
1.89 mm
Large burner - main
To Convert Surface Burners
0.69 mm
Large burner - simmer
1.
If installed, remove the burner grates.
2.
Remove burner cap.
3.
Remove the burner head.
NOTE: A %%" socket must be used to remove the burner head
.
of the large dual burners.
Burner orifice spud
A. Size stamp
7.
Place LP gas orifice spuds in plastic parts bag for future use
and keep with package containing literature.
8.
Replace the burner base using both screws.
Replace burner head and cap.
10. Repeat steps 2 through 9 for the remaining burners.
27
Advertisement
Table of Contents
