Jenn-Air JGRP536WP00 Installation Instructions Manual page 19

Replace Oven Bake Burner Cover
1.
2.
Align rear shoulder screw mounting holes (keyholes) on the
oven bake burner cover with shoulder screws in the bottom
of the oven.
A. Shoulder screw mounting holes (keyholes)
B. Shoulder screws
Drop cover and slide to left or right to slide shoulder screws
into narrow ends of keyholes and lock in place.
4. Using a T15 Torx® screwdriver, remove the burner base.
Large Dual Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
Medium Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
Small Burner
A. Burner cap
B. Gas opening
C. Burner base
5. Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Insert nut driver into the gas opening and press down onto
the gas orifice spud and remove by turning the gas orifice
spud counterclockwise and lifting out. Set gas orifice spud
aside.
6. Replace with correct LP gas orifice spud. See the following
"LP Gas Orifice Soud/Hood Chart."
Use the following chart to find the exact orifice spud
placement.
LP Gas Orifice Spud/Hood Chart
Remove burner cap.
Remove the burner head.
NOTE: A %" socket must be used to remove the burner head
of the large dual burners.
Burner Color Size Burner Style
Rating
3,000 BTU Blue 0.55 mm Small burners
12,500 BTU Brass 1.04 mm Medium burners
A. Bake burner cover
To Convert Surface Burners
. 15,500 BTU Yellow 1.05mm Large burner - main
. lfinstalled, remove the burner grates. .
9 Green 0.45 mm Large burner - simmer
A. Size stamp or color
Place Natural gas orifice in plastic parts bag for future use
and keep with package containing literature.
Replace the burner base using both screws.
Replace burner head and cap.
10. Repeat steps 2 through 9 for the remaining burners.
11. Unplug range or disconnect power.
19