Jenn-Air JGRP536WP00 Installation Instructions Manual page 14

30" (76.2 cm), 36" (91.4 cm) and 48" (121.9 cm) pro-style gas convection ranges
Hide thumbs Also See for JGRP536WP00:
Table of Contents

Advertisement

Available languages

Available languages

6.
Turn over the gas pressure regulator cap and reinstall on the
3.
Slide the bake burner cover to the right or left.
regulator so that the hollow end faces out and the letters "LP"
are visible.
7.
Tighten the gas pressure regulator cap by using a
large flat-
blade screwdriver, turning the regulator cap clockwise.
8.
Test the gas pressure regulator and gas supply line.
4.
Lift up and remove oven bake burner cover and set aside.
The regulator must be checked at a minimum 1" (2.5 cm)
5.
Unscrew oven baffle nuts and remove oven baffle. Set aside.
water column above the set pressure. The inlet pressure to
the regulator should be as follows for operation and checking
the regulator setting:
LP Gas:
Minimum
pressure 11" (27.9 cm) WCP
Maximum
pressure 14" (85.6 cm) WCP.
A. Bake burner cover
Gas Supply Pressure Testing
Gas supply pressure for testing regulator must be at least
1" water column pressure above the manifold pressure
shown on the model/serial rating plate.
Line pressure testing above '2 psi gauge (14" WCP)
The range and its individual shutoff valve must be
disconnected from the gas supply piping system during any
pressure testing of that system at test pressures in excess of
Ye psi (8.5 kPa).
Line pressure testing at 2 psi gauge (14" WCP) or lower
The range must be isolated from the gas supply piping
system by closing its individual manual shutoff valve during
A. Oven baffle
any pressure testing of the gas supply piping system at test
B. Oven baffle nuts
pressures equal to or less than % psi (3.5 kPa).
6.
Remove the oven bake burner screws and oven bake burner
To Convert Oven Bake Burner (30" [76.2 cm] and 36"
and gently set aside.
[91.4 cm] models and the Right Oven Cavity on 48"
[121.9 cm] models)
1.
Remove oven racks and the extendable roller rack from
inside the oven cavity. See the "Extendable Roller Rack"
section in the Use and Care Guide.
AWARNING
Excessive Weight Hazard
Use two or more people to move and install oven
doors.
Failure to do so can result in back or other injury.
2.
Remove the oven door. See the "Oven Door" section in the
Use and Care Guide.
A. Oven bake burner screws
B. Oven bake burner
C. Oven bake burner electrode bracket
D. Oven bake burner electrode
14

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jgrp430wp00Jgrp436wp00

Table of Contents