Nikon ECLIPSE E400 Instructions Manual page 4

CAUTION
E Installation location
performance or damaging the equipment.
Check the light source
The power supply contained in the microscope provides the power for the halogen lamp as the microscope light
source. Although this power supply can power a halogen lamp of up to 6 V-30 W, the specified lamp must be used.
Use of a non-specified lamp could damage the microscope.
Specified lamp: 6 V-30 W (PHILIPS 5761)
Cautions when replacing the lamp
In order to prevent burns, allow the lamp to cool (for at least thirty minutes after turning off the power) before replacing
the lamp. Furthermore, to prevent electrical shock and damage to the microscope, always turn off the power switch
(flip it to the" " side) and unplug the power cord before replacing the lamp.
After replacing the lamp, be sure to attach the lamp cover securely. Never use the lamp without its cover.
Cautions when operating the stage
The stage rack protrudes outward when the stage is moved.
When operating the focus knobs or condenser focus knob, be
careful not to bump your hand on the rack since the end of
the rack may injure your hand.
n em ta aray mmm oem araras rg .. arm ne -en P,