Table of Contents
Advertisement
I
SAFETY
INSTRUCTIONS
I
Precautions
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRICSHOCK, DO NOT
REMOVE THE COVER (OR BACK).
NO USER-SERVICEABLEPARTSARE INSIDE. REFER
SERVICINGTO QUALIFIED SERVICE PERSONNEL.
This symbol indicates "dangerous voltage"
inside the product that presents a risk of
electric shock or personal injury.
This symbol indicates important
instructions accompanying the
product.
Do not install this equipment in a confined space such as a bookcase or similar unit.
WARNING
: To prevent damage which may result in fire or electric shock hazard, do not expose
this appliance to rain or moisture.
Note to CATV system installer: This reminder is provided to call CATV system instalIer's attention to Article
820-40 of the National ElectricalCode (Section 54 of Canadian Electrical Code, Part I) that provides guidelines
for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding
system of the building as close to the point of cable entry as practical.
Caution: FCC regulations state that any unauthorized changes or modifications to this equipment may void the
user's authority to operate it.
• Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall
be placed on the apparatus.
• If this power supply is used at 240V ac, a suitable plug adapter should be used.
FCC NOTE (for U,S.A):
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interferenceto radio or television
reception, which can be determined by turning the equipment off and on.
The user is encouraged to try to correct the interference by one or more of the following measures.
• Reposition or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect this equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radiofrV technician for help.
This class B digital apparatus meets all requirements of the Canadian Interference --
Causing Equipment Regulations.
ENG-3
Advertisement
Table of Contents
