Scan And Ir Sync; Manual Frequency Selection; Using The Guided Frequency Setup - Shure SLX-D Manual

Scan and IR Sync

Group scan identifies the number of available channels in each group, and automatically assigns an available channel within
your selected group. Perform a channel scan if you want to find a new channel, or if you are using the manual frequency selec­
tion method (see Manual Frequency Selection).
To perform a group scan:
1. Turn off all transmitters you plan to use with your system, and select Frequency > Group Scan.
2. The group with the most available channels is displayed. Use the arrow buttons to change the group number and view
available channels in each group.
3. Push the Enter button to set the receiver to the group and channel shown on the display.
To perform a channel scan:
1. Turn off all transmitters you plan to use with your system, and select Frequency > Channel Scan.
2. Use the arrow buttons to select the group for your receiver. The group should be the same as other receivers in the
same frequency band.
3. Push the Enter button to start the channel scan.
4. Confirm the selected channel with Enter, or use the arrow buttons to view other available channels.
After running the appropriate scan, turn on the transmitter you plan to use with this receiver, align the infrared (IR) ports on the
transmitter and receiver, and push the sync button.

Manual Frequency Selection

To manually adjust group, channel or frequency:
1. Enter the Manual Frequency Setup screen on the receiver and select and adjust the group (G), channel (C), or frequen­
cy (MHz) as needed.
2. Select Apply and confirm to save your settings.
3. Align the infrared (IR) ports on the transmitter and receiver, and push the sync button.

Using the Guided Frequency Setup

SLXD4 and SLXD4D systems include a guided frequency setup to walk through the group and channel scan process.
To set up a new SLXD4 or SLXD4D system:
1. Select Initialize My System and push the control knob to continue.
2. Turn off all transmitters you plan to use with your system, and select start scan.
3. After the scan is done, push the control knob to assign frequencies to the receiver.
4. Turn on the transmitter you plan to use with this receiver.
5. Align the infrared (IR) ports on the transmitter and receiver, and push the sync button.
Shure Incorporated
27/56