Supplied Fittings; Indoor Unit Installation - Bosch Climate 5000 VRF FSC-B Series Installation & User Manual

4 | SUPPLIED FITTINGS

3. SUPPLIED FITTINGS
Please check whether the following fittings are supplied. If there are some
spare fittings, please keep them carefully.
Name of Accessories Qty
Ower's manual 1
Installation manual 1
Pipe insulation
2
material
Signal receiver
1
display board
Mounting screw
4
(ST3.9x12-C-H)
Copper nut 1
Network matching
2
wire
Remote alarm signal
1
wire
Remote control signal
1
wire
(The following contents only applicable for the unit with a remote controller)
Remote controller & Its Frame
1. Remote controller ............................................... 1
2. Remote controller holder ..................................... 1
3. Mounting screw (ST2.9x10-C-H) .......................... 2
4. Alkaline dry battery (AM4) ................................... 2
AUTO
TEMP
COOL Mounting screw B
SET
DRY
CLOCK
HEAT SET
ST2.9x10-C-H
HOUR
FAN
FAN SPEED
FAN
MODE
SPEED
M
SWING AIR DIRECTION CLOCK
SWING OK TIME ON
RESET LOCK C/H ECO TIME OFF
Remote controller holder
Remote controller
6720866023 (2017/11)
Outline Usage
_________ _________
(This manual) _________
Heat insulation
Receive signal
_________
Use for pipe
connection of
engineering
installation
The indoor
unit which at
the terminal
of communi-
cation system
should connect
a impedance
between port P
and port Q
_________ Optional
_________ Optional
Fig. 3-1
CAUTION
Do not damage the controller.
■
Before installation, operate the remote controller to determine its
■
location in a reception range.
Keep the remote controller at least 1m apart from the nearest TV set
■
or stereo equipment. (It is necessary to prevent image disturbances
or noise interferences.)
Do not install the remote controller in a place exposed to direct
■
sunlight or close to a heating source, such as a stove.
Note that the positive and negative poles are correctly installed
■
when loading batteries.
NOTE
This manual is subject to changes due to technological improvement
■
without further notices.

4. INDOOR UNIT INSTALLATION

4.1 The units may be mounted vertically, provided
that the correct clearances for positioning are
maintained. (Refer to Fig. 4-1~Fig. 4-5 )
Version I
■
Vertical unit with casing,with air intake from front and air outlet on
top, for installation on a wall or on feet on the floor.
a
a
a
Fig. 4-1
a
Fig. 4-2
Climate 5000 VRF