Table of Contents
Advertisement
Checking and adjusting the tire
inflation pressure
Checking
1.
Switch off the compressor.
2.
Read the tire pressure on the tire pressure
display.
To continue the trip, a tire pressure of at least
2 bar/29 psi must be reached.
Removing and stowing the sealant
bottle
1.
Unscrew the filler hose of the sealant bottle
from the tire valve.
2.
Press the red unlocking device.
3.
Remove the sealant bottle from the com-
pressor.
4.
Wrap and store the sealant bottle in suita-
ble material to avoid contamination of the
cargo area.
Minimum tire inflation pressure is not
reached
1.
Pull the connector out of the power socket
in the vehicle interior.
2.
Drive 33 ft/10 m forward and back to dis-
tribute the sealing compound in the tire.
3.
Screw the connection hose of the compres-
sor directly onto the tire valve stem.
Online Edition for Part no. 01405A5F6E0 - VI/22
Wheels and tires
4.
Insert the connector into the power socket
in the vehicle interior.
5.
With standby or drive readiness turned on,
turn on the compressor and let it run for a
maximum of 10 minutes.
If the tire pressures does not reach at least
2 bar/29 psi, contact an authorized service
center or another qualified service center or
a repair shop.
When a tire pressure of at least 2 bar/29 psi
is reached, see Minimum tire pressure is
reached.
6.
Unscrew the connection hose of the com-
pressor from the tire valve.
7.
Pull the connector out of the power socket
in the vehicle interior.
8.
Stow the tire repair set in the vehicle.
Minimum tire inflation pressure is
reached
1.
Unscrew the connection hose of the com-
pressor from the tire valve.
2.
Pull the connector out of the power socket
in the vehicle interior.
3.
Stow the tire repair set in the vehicle.
4.
Immediately drive approx. 5 miles/10 km to
ensure that the sealing compound is evenly
distributed in the tire.
Do not exceed a speed of
50 mph/80 km/h.
If possible, do not drive at speeds less than
12 mph/20 km/h.
MOBILITY
303
Advertisement
Table of Contents
