BMW SEDAN 3 Series 2023 Owner's Manual page 207

The stored speed is displayed on the speed-
ometer.
If necessary, the Dynamic Stability Control will
be turned on.
The speed can also be stored by pressing a
button.
Press the button.
Changing the speed
Press the rocker switch up or down repeatedly
until the desired speed is set.
If active, the displayed speed is stored and
the vehicle reaches the stored speed when the
road is clear.
▷ Each time the rocker switch is tapped to the
resistance point, the set speed increases or
decreases by 1 mph/1 km/h.
▷ Each time the rocker switch is pressed
past the resistance point, the desired speed
changes by a maximum of 5 mph/10 km/h.
The maximum speed that can be set de-
pends on the vehicle.
▷ Pressing the rocker switch to the resistance
point and holding it: vehicle accelerates or
decelerates without pressure on the accel-
erator pedal.
After the rocker switch is released, the vehi-
cle maintains its final speed. Pressing the
switch beyond the resistance point causes
the vehicle to accelerate more rapidly.
Driver assistance systems
Online Edition for Part no. 01405A5F6E0 - VI/22
Continuing cruise control
An interrupted cruise control can be continued
by calling up the stored speed.
Make sure that the difference between current
speed and stored speed is not too large be-
fore calling up the stored speed. Otherwise,
unintentional deceleration or acceleration may
occur.
Press the button with the system inter-
rupted.
Cruise control is continued with the stored val-
ues.
In the following cases, the stored speed value
is deleted and cannot be called up again:
▷ When the system is switched off.
▷ When drive-ready state is switched off.
Displays in the instrument cluster
Display in the speedometer
Depending on the equipment, a mark in the
speedometer displays the status of the sys-
tem.
▷ Green marking: system is ac-
tive, the marking indicates
the desired speed.
▷ Gray marking: system is in-
terrupted, the marking indi-
cates the stored speed.
▷ No marking: system is switched off.
Indicator light
▷ Indicator light green: system is ac-
tive.
▷ Gray indicator light: the system has
been interrupted.
▷ No indicator light: system is switched off.
CONTROLS
207