Advertisement
13
Converting the Mower
Deck for Rear-Discharge
Operation
Parts needed for this procedure:
8
Flange-head bolt (3/8 x 1 inch)
Preparing to Remove the Recycler
Kit
1.
Prepare the mower; refer to
Mower (page
3).
2.
Gas models only, remove the guard and
remove the left belt cover; refer to
the Engine Guard and Removing the Guard
Extension (Gas Models Only) (page 3)
Removing the Left Belt Cover (Gas Models
Only) (page
4).
3.
Remove the recycling blades; refer to the
Operator's Manual for your machine.
Removing the Kickers
Reverse the steps in
9 Installing the Kickers (page
12)
and install new flange-head bolts (3/8 x 1 inch)
and previously removed locknuts (3/8 inch) where you
removed the kickers.
Removing the Baffles
Reverse the steps in
7 Installing the Baffles (Gas
Models Only) (page 8)
(Electric Models Only) (page 10)
flange-head bolts (3/8 x 1 inch) and previously
removed locknuts (3/8 inch) where you removed the
baffles.
Removing the Baffle Supports
Reverse the steps in
6 Installing the Baffle Supports
(page 6)
and install the previously removed carriage
bolts (5/16 x 7/8 inch) and locknuts (5/16 inch) where
you removed the baffle supports.
Finishing Converting the Mower
Deck for Rear-Discharge Operation
1.
Install the non-recycling blades; refer to the
Operator's Manual for your machine.
1 Preparing the
2 Opening
and
or
8 Installing the Baffles
and install new
2.
Gas models only: install the belt cover and
guard; refer to
(Gas Models Only) (page 13)
the Guard Extension and Closing the Engine
Guard (Gas Models Only) (page
3
16
11 Installing the Left Belt Cover
and
12 Installing
14).
Advertisement
